LCC60 driver/dimmer for constant current, voltage LED lights, Vadsbo

LCC60 driver/dimmer for constant current and voltage LED lights. Load up to 2 x 30W

- LED control gear LCC60 (a combination of LED-driver and LED-dimmer in one device).
- Suitable for constant current and constant voltage loads.
- Load up to 2 x 30W (see table).
- Dimming: push button retractive/momentary switch, 1-10V

Input voltage 220-240VAC (screw terminal) 
Two outputs
Single output offers as follow: 
a) Constant current
350mA (2-57V) 1-20W (1-16 st LED)
500mA (2-54V) 2-27W (1-15 st LED)
700mA (2-43V) 3-30W (1-12 st LED)
900mA (2-27V) 4-24 W (1-7 st LED)
b) Constant voltage: 12Vdc (max 10.8W) / 24Vdc (max 21.5W)

Dimming control:
- Primary side: push-button retractive/momentary switches
- Secondary side: 1-10Vdc controller
Quick-connection terminals for easy connection
Easy to install in suspended ceiling thanks its small dimensions (easy entrance into a 75-80mm hole)
Dimensions (LxWxH): 220x58x40mm
Holes for mounting screws to wall or similar surface
Max. ambient temperature: +50ºC
Weight: 250g
Housing: thermoplastic, white
Connection wires: 1.5mm²
Dimming: push-button retractive switch or potentiometer (1-10VDC, I=0.35mA)
Synchronization without sync cable
Max. cable lengths (primary side): 15meters between the first driver and push button; 15meters between drivers
Max. cable lengths (secondary side): 20meters to the luminaries; 40 meters in a loop
Mixed loads possible
Soft start
Memory function
Constant voltage protection
Overload protection
Over temperature protection
Approved for mounting on furniture 
DIP-switch: using the DIP switch can set the type of LED you want to dim
Selectable constant currents: 350mA, 500mA, 700mA, 900mA
Selectable constant voltages: 12VDC, 24VDC
Standards: EN55015; EN61547; EN61347-1; EN61347-2-13
Insulation class II
IP20
Approval: S/CE
EMC

LCC60 can be used in a system for driving and dimming of both LED strips and LED lamps in the same time.